Skip to the page
Plumbers in MarkhamHomes · businesses · drains · heaters

Commercial · Toilets, sinks & showers

Office and retail plumbing in Markham

Staff washrooms, customer restrooms, kitchenettes and small water heaters keep a plaza unit open. We repair flush valves, sensor faucets, clogged urinals and leaking supply lines, and keep your taps dry for the shortest stretch possible.

  • Flushometers and touchless taps rebuilt
  • Washroom clogs cleared without closing the unit
  • Small tank and point-of-use heaters swapped
  • Isolation valves added so one leak never shuts the floor
Ring us at (365) 334-6254Call-only: a plumber picks up, no forms.
  • Licensed plumbers (details on request)
  • Price agreed before work
  • Call-only, no forms
  • Tested before we leave
A bright bathroom with a white toilet and sink
A quiet bathroom, which is how a toilet should sound after the flush

Common office and retail calls

  • Toilets and urinals that keep running, flush twice or barely flush
  • Sensor faucets dripping or failing to turn on
  • Staff kitchen sinks clogged with coffee grounds
  • Small electric heaters leaking in a ceiling or closet
  • Water stains on drop-ceiling tiles from a hidden supply leak

How the repair runs

  1. Talk to the manager about hours and which fixtures can be closed.
  2. Shut the nearest isolation valve, not the building main, where one exists.
  3. Rebuild or replace the flush valve, cartridge or sensor module.
  4. Clear any drain with a closet auger or cable sized to the line.
  5. Restore water, test each fixture and check the ceiling below.

Signs to call sooner

  • A meter or water bill rising while staff numbers stay the same
  • A washroom that smells of sewer after weekends
  • A ceiling tile sagging under a washroom or kitchenette

What is included

  • Fixture parts matched to the brand on the wall where possible
  • A written ticket listing what was rebuilt or replaced
  • Notes on any fixtures that will need attention soon

Markham plaza plumbing

Markham's plazas and office parks were mostly built from the 1980s on, so their washrooms now carry thirty-year-old flush valves, stops that seize and shared drain lines between units. Older retail on Main Street Markham and Main Street Unionville sits in heritage buildings where cast iron and galvanized pipe can still turn up above the ceiling. If the building has a property manager, we coordinate shut-offs with them before we start.

Older retail on Main Street Markham and Main Street Unionville sits in heritage buildings where cast iron and galvanized pipe can still turn up above the ceiling.

From the job notes of Plumbers in Markham

Job card · Toilets, sinks & showers

On the van for this job

  • Wax rings, closet bolts, flappers and fill valves
  • Cartridges for common shower and faucet brands

Signs you need this

  • The toilet runs or refills on its own
  • The shower goes scalding when someone flushes

What we check before we pack up

  1. Fill and drain the fixture and watch every joint
  2. Set temperature limits on shower valves
Toilets, sinks & showers: a quick reference
FixtureParts that wearWhat to know
ToiletFlapper, fill valve, wax ringRocking means bolts or wax
Shower valvePressure-balance cartridgeAccess panel saves tile

How the job runs, start to finish

  1. 1

    On the phone

    Explain what the water is doing and where. We ask the age of the house and which valve or breaker to shut while we drive over.

  2. 2

    Drop cloths down

    Floors and cabinets get covered, the water or gas is isolated and the work area is lit.

  3. 3

    Find the failed part

    We open the trap, cleanout, access panel or wall where the fault is, and show you what we found.

  4. 4

    Quote, then work

    We explain what failed and what the fix costs; no cutting starts until you say yes.

  5. 5

    Cut, fit, seal

    Old parts come out, new pipe, valves or fixtures go in, and joints are soldered, pressed, crimped or glued.

  6. 6

    Test and ticket

    We run water, pressure-test or fire the heater, check for drips, clean up and leave a written ticket of what was done.

Quick answers

Can you fix a flushometer without shutting down the washroom?
Most flush valves have their own stop. We close it, rebuild the valve and have the fixture back in service quickly, while the rest of the washroom stays open.
Do you work for tenants or landlords?
Either. If the lease makes the landlord responsible for plumbing, we can coordinate with the property manager before work starts.
Call a plumber · (365) 334-6254